Concrete Turns Colorful
April 13th, 2009 @ 7:30am

Get the Flash Player to see this player.

Embed:

Fix-It Chick, Amber Anderson shows us how to stain and seal concrete for a dramatic flooring alternative.














Where to use:

• For uncoated and unsealed, properly prepared Interior or Exterior Patios, Pavers, Driveways*,Walkways*,Garage Floors, Pool or Cool Decks and other concrete floors.
*Important note for driveways and garages: The composition of concrete varies; therefore, the lack of proprer surface preparation and/or over application can lead to automobile tires lifting the product from the surface.


*Only light or pastel colored concrete stains should be used. DARK COLORS RETAIN HEAT.

Prepartion:

• New concrete must cure for a minimum of 30 days.
• Remove old coatings and sealer, if present, Use BEHR NO. 992 CONCRETE & MASONRY PAINT STRIPPER. Follow all lable instructions.
• Test: sprinkle a few drops of water on the surface. If water is quickly absorbed the suface is ready. If not absorbed, re-etch.
• for proper preparation and adhesion of topcoat, use BEHR NO. 991 CONCRETE & MASONRY CLEANER/ETCHER to clean and etch the surface. Follow the label Instructions.
• If there are mildew stains they will need to be removed, try using BEHR NO. 62 PREMIUM MILDEW STAIN REMOVER. Follow all lable instuctions.
• For better top coat adhesion use BEHR NO. 880 CONCRETE & MASONRY BONDING PRIMER.

Application:


• Do not thin stain. Intermix cans of same product to insure color uniformity.
• Stir thoroughly befor and during application and use stain when tempuratures are between 50 and 90*F. Don't apply in direct sun light.
• Apply to dry concrete. Do not applly if rain or heavey dew is expected within 24 hours.
• Apply stain in small 4'x4' sections, working quickly and feathering the edges.
• Apply with a High quality pump sprayer at a fine spray setting.
• Allow first coat to dry 4 hours before deciding if a second coat is needed or appling sealer.

For added protection:


• For high gloss look BEHR NO. 985 WET LOOK SEALER
• For low gloss finish BEHR NO. 986 LOW LUSTER SEALER

Dry time:

• Dries to the touch in 1 hour.
• Light foot trafic after 24 hour.
• Furniture after 72 hours.


If you have questions regarding proper disposal of chemicals and materials, visit www.earth911.org or call (800) CLEAN UP.

| Show Info | Recipes | Community | About Us | Contact Us | Search | User Accounts | Contact Form | Ask a Pharmacist | Jobs |
©KSL Television & Radio, Salt Lake City UT      A Division of Bonneville International   m28
      Terms of Use      Bonneville's Values      EEO Public File Report